Leveling the Top of a Sectioned Wall

Home > 05 Walls > Leveling the Top of a Sectioned Wall

$image\SHORTCUT.gif$ Back to the Main Topic

Leveling the Top of a Sectioned Wall

Level the top of a sectioned wall.

\ucorn

$image\ebx_1693072387.gif$ NOTE This command is applicable to sectioned walls only.

$image\ebx_-640464384.gif$

When a wall is sectioned the top of the wall may slope across its width — i.e., the height of the internal and external wall surfaces may not be identical in cross section. Use this command to level the top of the wall horizontally irrespective of any slope along its length.

$image\ebx_-488573230.gif$ $image\ebx_2054862795.gif$

Operation

Specify whether you wish to operate on a single wall, a selection group or on all walls. Specify whether the wall is to be leveled to the higher or lower side of the slope.

If you specify a single wall, indicate the wall.

$image\ebx_1693072387.gif$ NOTE This command does not affect the slope of a wall along its length. Only the slope across the width of the wall will be corrected.